How does harness manufacturer monitor harness quality? The manufacturer of pin connector tells you

No matter what kind of products are produced, there should be problems in the control of product quality. It is the same for the simple corner bracket specification binding processing factory. How should the binding processing factory control the product quality?

1. First of all, it needs the vocational training of the processing staff, each unit arranges the corresponding technical personnel for on-site guidance and solution, and should take the staff reward and punishment measures.

2. The quality department can be set up to supervise every link of wire harness processing every day, take photos, and reward and punish every week.

3. Update the existing production technology at any time, continuously measure the wire processing time and process, and constantly improve and correct the existing technology.

4. Production department should make production plan in time and inform technology and quality department to monitor new products.

The development should be miniaturized. Many products are faced with smaller and lighter development. There are certain requirements for the spacing and appearance size, and the requirements for products are more precise. For example, small spacing of 0.6 mm and 0.8 mm, high density, high-speed transmission and high frequency are selected for line to board development. Miniaturization means that the center spacing of a single row of needles is smaller, and the high density realizes the large number of cores.

The function of single row of pins is to bridge the cut-off or isolated circuits in the circuit and undertake the task of current and signal transmission. It is usually used in combination with the bus bar to form the board to board connection or with the wiring harness. The board to board connection forming the board to line connection can also be used independently. When people choose single row needles, they first consider the cost control. The other is the design features of high quality, high stability and single row needles. In order to avoid underestimating the importance of single row needles in the design process, we will put forward some suggestions. That is the design must have a double pole design concept, the need for solid design and so on.